Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0242031 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E267170C28
1.438,0.333 1.833,0.573 0.396,0.24 1.563,1.313 0.906,0.625 false 1.979,1.313 2.635,0.625 false 0.094,0.104 0.344,0.292 0.25,0.188 10 false *a 0.74,0.417 1.031,0.604 0.292,0.188 10 false ES 2.542,0.417 2.833,0.604 0.292,0.188 10 false SIG 1.531,0.354 1.823,0.542 0.292,0.188 10 false O1
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the O1 rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
O1-4 (SIG) - O1-2 (ES) Power switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O1-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.
E257042C16
1.646,0.938 1.135,0.417 false 1.771,0.927 2.281,0.406 false 0.083,0.073 0.313,0.26 0.229,0.188 10 false *a 2.313,0.271 2.771,0.427 0.458,0.156 10 false ES 0.854,0.229 1.365,0.385 0.51,0.156 10 false MPX
*a Component with harness connected
(Rain Sensor)


Reconnect the O1 rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
3 (MPX) - 2 (ES) Power switch on (IG) Pulse generation


If the result is not as specified, replace the rain sensor.