Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0242032 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53875A 2.REMOVE FRONT FENDER LINER RH

a.
E337175

Remove the 3 screws.


b.
E337176

Remove the 5 screws and grommet.


c.
E337177C02
2.24,0.438 2.438,0.604 0.198,0.167 10 true *a
*a 90°


Using a screwdriver, turn each pin 90 degrees and remove the 2 pin hold clips.


d.

for Rough Road Area Specification Vehicles:

i.
E337181

Remove the clip.



e.
E337180

Remove the 9 clips and front fender liner RH.


Hide 3.DRAIN WASHER FLUID

a.
E337182

Disconnect the rear washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 4.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E337183C02
0.938,1.885 1.052,1.802 false
V113147

Remove in this Direction


Disconnect the washer hose.


b.

Disconnect the connector.


c.

Remove the windshield washer motor and pump assembly as shown in the illustration.