CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
Disconnect the O10 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| O10-1 (B) - O10-2 (E) | L - W-B | Auxiliary battery power supply | Power switch off | 11 to 14 V |
| O10-6 (IG) - O10-2 (E) | LG - W-B | IG power supply | Power switch off | Below 1 V |
| Power switch on (IG) | 11 to 14 V | |||
| O10-2 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the O10 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| O10-10 (OPN) - O10-2 (E) | G - W-B | Sliding roof motor open | Power switch on (IG), OPEN switch on | Below 1 V |
| Power switch on (IG), OPEN switch off | 11 to 14 V | |||
| O10-8 (CLS) - O10-2 (E) | P - W-B | Sliding roof motor close | Power switch on (IG), CLOSE switch on | Below 1 V |
| Power switch on (IG), CLOSE switch off | 11 to 14 V | |||
| O10-5 (UP) - O10-2 (E) | V - W-B | Sliding roof motor up | Power switch on (IG), UP switch on | Below 1 V |
| Power switch on (IG), UP switch off | 11 to 14 V | |||
| O10-9 (DWN) - O10-2 (E) | B - W-B | Sliding roof motor down | Power switch on (IG), DOWN switch on | Below 1 V |
| Power switch on (IG), DOWN switch off | 11 to 14 V |
CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>TERMINALS OF ECU