84930
1.INSPECT DOOR CONTROL SWITCH ASSEMBLY
| *a | Component without harness connected
(Door Control Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 - 5 | Lock switch pushed | Below 200 Ω |
| 4 - 5 | Lock switch not pushed | 1 MΩ or higher |
| 2 - 5 | Unlock switch not pushed | 1 MΩ or higher |
| 2 - 5 | Unlock switch pushed | Below 200 Ω |
If the result is not as specified, replace the door control switch assembly.