Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM3210E _55 Steering _047547 POWER ASSIST SYSTEMS _0242387 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TERMINALS OF ECU  


CHECK POWER STEERING ECU ASSEMBLY


C319555C09
1.938,0.333 2.354,0.583 0.417,0.25 4.25,0.333 4.667,0.583 0.417,0.25 5.365,0.333 5.781,0.583 0.417,0.25 2.031,0.365 2.49,0.563 0.458,0.198 10 false F54 0.24,0.083 0.698,0.281 0.458,0.198 10 false *a 4.344,0.365 4.802,0.563 0.458,0.198 10 false z17 5.448,0.365 5.906,0.563 0.458,0.198 10 false F20
*a Component without harness connected
(Power Steering ECU Assembly)
- -


a.

Measure the voltage and resistance according to the value(s) in the table below.

NOTICE:

When the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU assembly terminals to become 0 V.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F20-1 (IG) - Body ground L - Body ground IG power source Power switch on (IG) 8 to 16 V
F20-7 (CANH) - F20-8 (CANL) V - W CAN communication line Power switch off 54 to 69 Ω
z17-1 (TRQ2) - z17-2 (TRQG2) Y - G Torque sensor 2 signal Power switch on (READY) and steering wheel not being turned (without load) 2.3 to 2.7 V
Power switch on (READY) and steering wheel being turned to the right with vehicle stopped 1.2 to 2.5 V
Power switch on (READY) and steering wheel being turned to the left with vehicle stopped 2.5 to 3.8 V
z17-2 (TRQG2) - Body ground G - Body ground Torque sensor 2 ground Always Below 1 Ω
z17-3 (TRQV2) - z17-2 (TRQG2) L - G Torque sensor 2 voltage source Power switch on (IG) 4.5 to 5.5 V
z17-7 (TRQV1) - z17-8 (TRQG1) R - B Torque sensor 1 voltage source Power switch on (IG) 4.5 to 5.5 V
z17-8 (TRQG1) - Body ground B - Body ground Torque sensor 1 ground Always Below 1 Ω
z17-9 (TRQ1) - z17-8 (TRQG1) W - B Torque sensor signal Power switch on (READY) and steering wheel not being turned (without load) 2.3 to 2.7 V
Power switch on (READY) and steering wheel being turned to the right with vehicle stopped 2.5 to 3.8 V
Power switch on (READY) and steering wheel being turned to the left with vehicle stopped 1.2 to 2.5 V
F54-1 (PIG) - Body ground B-W - Body ground Power source Power switch on (IG) 9 to 16 V
F54-2 (PGND) - Body ground W-B - Body ground Power ground Always Below 1 Ω

If the result is not as specified, the ECU may be malfunctioning.