Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM3210E _58 Vehicle Interior _047532 POWER OUTLETS (INT) _0242464 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Power Source Circuit  


DESCRIPTION

This is the power source circuit for the mobile wireless charger cradle assembly.

WIRING DIAGRAM

E299682E15
5.271,2.854 5.833,3.063 0.563,0.208 10 false F90 5.271,3.042 6.823,3.375 1.552,0.333 10 false Mobile Wireless Charger Cradle Assembly 5.604,2.302 7.156,2.635 1.552,0.333 10 false PGND 5.604,1.51 7.156,1.844 1.552,0.333 10 false ACC 5.604,0.688 7.156,1.021 1.552,0.333 10 false B+ 3.646,1.667 4.354,1.938 0.708,0.271 10 false ECU-ACC 3.469,0.854 4.573,1.156 1.104,0.302 10 false ECU-DCC NO. 2 1.573,1.51 3.125,1.844 1.552,0.333 10 false from ACC Relay 1.24,0.698 2.708,0.979 1.469,0.281 10 false from Auxiliary Battery 5.406,0.594 6.958,0.927 1.552,0.333 10 false 6 5.406,1.385 6.958,1.719 1.552,0.333 10 false 5 5.396,2.188 6.948,2.521 1.552,0.333 10 false 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY POWER SOURCE)
a.

Disconnect the F90 mobile wireless charger cradle assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F90-1 (PGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F90-6 (B+) - Body ground Power switch off 11 to 14 V
F90-5 (ACC) - Body ground Power switch on (ACC) 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR