Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM3210E _58 Vehicle Interior _047532 POWER OUTLETS (INT) _0242464 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Illumination Circuit  


DESCRIPTION

When the light control switch is turned to the tail or head position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.

WIRING DIAGRAM

E336459E03
4.583,2.125 6.146,2.531 1.563,0.406 10 false Mobile Wireless Charger Cradle Assembly 0.635,0.49 1.688,0.802 1.052,0.313 10 false from TAIL Relay 2.49,0.688 3.188,0.948 0.698,0.26 10 false PANEL 4.927,0.531 5.625,0.792 0.698,0.26 10 false TAIL 4.927,1.583 5.625,1.844 0.698,0.26 10 false ILL- 4.656,0.438 5.354,0.698 0.698,0.26 10 false 10 4.729,1.469 5.427,1.729 0.698,0.26 10 false 9 4.583,1.958 5.281,2.219 0.698,0.26 10 false F90

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the F90 mobile wireless charger cradle assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F90-10 (TAIL) - Body ground Light control switch in off position Below 1 V
Power switch off, light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F90-9 (ILL-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR