Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM WARNING BUZZER
RM3210E _58 Vehicle Interior _047529 PRE-CRASH SAFETY _0242558 PRE-CRASH SAFETY SYSTEM WARNING BUZZER G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM WARNING BUZZER  INSPECTION  


PROCEDURE

Hide 86652F 1.INSPECT SKID CONTROL BUZZER

a.
A303614

Make sure that there is no looseness in the locking part and connecting part of the connector.


b.

Disconnect the skid control buzzer connector.


c.

Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer, and check that the buzzer sounds.

OK:

The skid control buzzer sounds.


If the result is not as specified, replace the skid control buzzer.