Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM3210E _55 Steering _047548 STEERING COLUMN _0242570 STEERING COLUMN ASSEMBLY G

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C346849C01
2.188,0.906 2.885,0.906 true 0.469,1.271 1.167,1.271 true 0.771,1.281 0.771,1.729 0.771,1.729 1.167,1.729 true 0.771,1.5 1.167,1.5 true 0.281,1.177 0.594,1.333 0.313,0.156 10 false *a 2.917,0.823 3.229,0.979 0.313,0.156 10 false *b
*a Wooden Block
*b Cloth


Secure the steering column assembly in a vise using aluminum plates, cloths and wooden blocks.

NOTICE:
·

Do not overtighten the vise, as the steering column assembly may become deformed.

·

Support the steering column assembly with wooden blocks or similar items to ensure that it does not fall.




b.
C220801C21
2.698,1.802 1.438,1.802 1.438,1.802 1.438,1.323 false 1.552,1.802 1.552,1.271 false 2.75,1.719 3.063,1.875 0.313,0.156 10 false *a
*a Service Nut


Install 2 service nuts to the steering main shaft.

Recommended Service Nut:
Thread Diameter:

12.0 mm (0.472 in.)

Thread Pitch:

1.25 mm (0.0492 in.)



c.

Simultaneously rotate the service nut that was installed first counterclockwise and rotate the service nut that was installed second clockwise to lock them.

NOTICE:

Do not apply excessive torque to the service nuts by using a tool such as an impact wrench.


HINT:

The service nuts are used for turning the steering main shaft during inspection of the steering main shaft rotating torque.

Remove the service nuts after performing this inspection.



d.
C346851

Using a torque wrench, turn the steering main shaft at a constant rate of approximately 1 revolution every 4 seconds and measure the preload.

Preload:

1.1 to 2.3 N*m (12 to 23 kgf*cm, 10 to 20 in.*lbf)


If the preload is not as specified, replace the power steering ECU assembly or electric power steering column sub-assembly with a new one.


e.

Remove the 2 service nuts.


Hide 2.INSPECT STEERING COLUMN ASSEMBLY

a.
C346852

Check that the 2 bushings are securely installed to the steering column assembly.

If the bushings are deformed, missing or damaged, replace the electric power steering column sub-assembly with a new one.