Home › Vehicle Exterior › HORN › HORN
RM3210E _59 Vehicle Exterior _047540 HORN _0243307 HORN G

HORN  HORN  INSPECTION  


PROCEDURE

Hide 86510 1.INSPECT HIGH PITCHED HORN ASSEMBLY

a.
E336213C01
1.667,0.271 2.094,0.448 false 1.604,1.073 1.958,1.198 false 0.156,0.104 0.583,0.396 0.427,0.292 10 false *a 1.458,0.208 1.823,0.49 0.365,0.281 10 false *b 1.375,1.021 1.781,1.354 0.406,0.333 10 false 1
*a Component without harness connected
(High Pitched Horn Assembly)
*b Body ground


Apply auxiliary battery voltage and check the operation of the high pitched horn assembly according to the table below.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Body ground
Horn sounds


If the result is not as specified, replace the high pitched horn assembly.


Hide 86520 2.INSPECT LOW PITCHED HORN ASSEMBLY

a.
E336214C01
1.583,0.271 2.063,0.469 false 1.719,0.885 1.948,1.146 false 0.094,0.094 0.479,0.396 0.385,0.302 10 false *a 1.375,0.146 1.813,0.479 0.438,0.333 10 false *b 1.542,0.781 1.885,1.052 0.344,0.271 10 false 1
*a Component without harness connected
(Low Pitched Horn Assembly)
*b Body ground


Apply auxiliary battery voltage and check the operation of the low pitched horn assembly according to the table below.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Body ground
Horn sounds


If the result is not as specified, replace the low pitched horn assembly.