Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243320 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75561A 1.INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:

When installing new roof drip side finish moulding clips, remove any double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent.


a.
B435994C01
2.198,0.396 2.51,0.396 false 0.75,0.583 1.594,1.021 true 1.969,0.313 2.281,0.469 0.313,0.156 10 false *a 0.563,0.469 0.875,0.625 0.313,0.156 10 false *b
*a Adhesive
*b 2 to 3 mm Bead of Adhesive


Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to each new roof drip side finish moulding clip.

HINT:

Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1987 psi) or more (when the temperature is 23°C (73°F).)



b.

Install the roof drip side finish moulding clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the roof drip side finish moulding clips.

B435995N01
0.75,0.25 0.938,0.448 0.188,0.198 10 false A 2.042,0.177 2.25,0.406 0.208,0.229 10 false B 5.531,1.792 5.688,1.99 0.156,0.198 10 false C 6.26,1.729 6.448,1.917 0.188,0.188 10 false D

Standard Measurement:
Area Measurement Area Measurement
A 3.0 to 5.0 mm (0.118 to 0.197 in.) B 1.5 to 2.5 mm (0.0591 to 0.0984 in.)
C 3.0 to 5.0 mm (0.118 to 0.197 in.) D 1.4 to 2.4 mm (0.0551 to 0.0945 in.)



c.

Install the roof drip side finish moulding when 40 minutes or more have elapsed since the roof drip side finish moulding clips were installed.

HINT:
·

Initial hardening time: 40 minutes

·

Complete hardening time: 24 hours




Hide 75556C 2.INSTALL CENTER ROOF DRIP SIDE FINISH MOULDING

a.

Engage the 2 clips to install the center roof drip side finish moulding as shown in the illustration.

B435996N01
0.604,0.563 0.76,0.76 0.156,0.198 10 false A 6.073,1.406 6.229,1.604 0.156,0.198 10 false B

Standard Measurement:
Area Measurement Area Measurement
A 3.0 mm (0.118 in.) B 4.0 mm (0.157 in.)