Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
62506C
1.REMOVE QUARTER PILLAR COVER SUB-ASSEMBLY
When removing the quarter pillar cover sub-assembly, heat the vehicle body and quarter pillar cover sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Quarter Pillar Cover Sub-assembly | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body or quarter pillar cover sub-assembly excessively.
Using a heat light, heat the quarter pillar cover sub-assembly.
| *a | Double-sided Tape |
|
Remove in this Direction |
Disengage the 6 clips and separate the double-sided tape as shown in the illustration to remove the quarter pillar cover sub-assembly.