Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM3210E _54 Brake _047522 PARKING BRAKE _0243352 PARKING BRAKE SWITCH G

PARKING BRAKE  PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84550 1.INSPECT PARKING BRAKE SWITCH ASSEMBLY

a.
C300450C02
2.313,0.917 2.844,0.917 true 0.958,1.083 0.958,1.281 0.958,1.281 1.167,1.281 true 2.156,0.823 2.469,0.979 0.313,0.156 10 false *a 1.219,1.198 1.531,1.354 0.313,0.156 10 false *b 0.052,0.729 0.365,0.885 0.313,0.156 10 false *c 0.531,0.729 0.844,0.885 0.313,0.156 10 false *d
*a Terminal
*b Nut
*c ON
*d OFF


Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.

Standard Resistance
Tester Connection Condition Specified Condition
Terminal - Nut On (When shaft is not pressed) Below 1 Ω
Terminal - Nut Off (When shaft is pressed) 10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.