Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM3210E _52 Drivetrain _047521 DRIVE SHAFT / PROPELLER SHAFT _0243355 FRONT DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C091598

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C296188N01
1.438,1.656 1.594,1.854 0.156,0.198 10 false A

Check whether each drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
LH Side RH Side
581.2 mm (1.91 ft.) 880.2 mm (2.89 ft.)