Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243397 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.


WIRING DIAGRAM

E265477E43
5.208,1.99 5.667,2.188 0.458,0.198 10 false F31 5.208,2.146 6.396,2.646 1.188,0.5 10 false Radio and Display Receiver Assembly 5.396,1.104 5.854,1.302 0.458,0.198 10 false REV 5.229,0.99 5.688,1.188 0.458,0.198 10 false 2 1.281,1.094 3.365,1.448 2.083,0.354 10 false from BKUP LP Relay


PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Move the shift lever to R and check that the back-up lights come on.

OK:

The back-up lights come on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the F31 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F31-2 (REV) - Body ground Power switch on (READY)
Reverse (R) selected
11 to 14 V
F31-2 (REV) - Body ground Power switch on (READY)
Shift state other than reverse (R) selected
Below 1 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR