1.INSTALL NAVIGATION ECU WITH WIRE (w/ Navigation System)
86140A
2.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
86212
3.INSTALL NO. 2 RADIO BRACKET
w/o Navigation System:
Install the No. 2 radio bracket with the 3 screws.
w/ Navigation System:
Install the No. 2 radio bracket with the 5 screws.
86211
4.INSTALL NO. 1 RADIO BRACKET
w/o Navigation System:
Install the No. 1 radio bracket with the 3 screws.
w/ Navigation System:
Install the No. 1 radio bracket with the 5 screws.
5.CONNECT NAVIGATION ECU WITH WIRE (w/ Navigation System)
Connect the 3 connectors to connect the navigation ECU with wire.
6.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
Connect each connector.
|
Install in this Direction |
Engage the 2 guides to temporarily install the radio receiver assembly with bracket as shown in the illustration.
Install the radio receiver assembly with bracket with the 4 bolts.
55405B
7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55435A
8.INSTALL INSTRUMENT PANEL FINISH PANEL END RH (for LHD)