Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243410 NOISE FILTER G

AUDIO / VIDEO  NOISE FILTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86011A 1.INSPECT RADIO SETTING CONDENSER

a.

With the radio setting condenser installed, check that there is no looseness or other abnormalities.


b.

Remove the bolt.


c.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


d.
E230106C19
1.963,0.576 2.428,0.576 false 2.088,1.588 2.541,1.425 false 1.348,1.589 0.816,1.427 false 2.443,0.492 2.553,0.649 0.111,0.157 10 3 2.554,1.33 2.665,1.487 0.111,0.157 10 2 0.707,1.317 0.817,1.474 0.111,0.157 10 1 0.062,0.075 0.269,0.232 0.207,0.157 10 *a
*a Radio Setting Condenser


Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

NOTICE:

Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.


Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2
·

Power switch on (IG)

·

Window defogger off


10 kΩ or higher
1 - 3 10 kΩ or higher
3 - Body ground Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
1 - Body ground
·

Power switch on (IG)

·

Window defogger off


Below 1 V
1 - Body ground
·

Power switch on (IG)

·

Window defogger on


11 to 14 V