Home › Drivetrain › P610 HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM
RM3210E _52 Drivetrain _047503 P610 HYBRID TRANSMISSION / TRANSAXLE _0243554 ELECTRONIC SHIFT LEVER SYSTEM D

P610 HYBRID TRANSMISSION / TRANSAXLE  ELECTRONIC SHIFT LEVER SYSTEM  UTILITY  


ALL READINESS


HINT:
·

With "All Readiness", you can use the GTS to check whether or not the DTC judgment has been completed.

·

Perform the "All Readiness" check after simulating malfunction symptoms or when performing validation after finishing repairs.



a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Clear the DTCs even if no DTCs are stored.

Powertrain > Hybrid Control > Clear DTCs
50002 397

e.

Turn the power switch off and wait for at least 30 seconds.


f.

Turn the power switch on (IG).


g.

Turn the GTS on.


h.

Perform the DTC confirmation driving pattern to run the DTC judgment.


i.

Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.

Powertrain > Hybrid Control > Utility
Tester Display
All Readiness
50005 397 20

j.

Input the DTCs to be confirmed.


k.

Check the DTC judgment result.

GTS Display Description
NORMAL
·

DTC judgment completed

·

System normal


ABNORMAL
·

DTC judgment completed

·

System abnormal


INCOMPLETE
·

DTC judgment not completed

·

Perform the driving pattern after confirming DTC enabling conditions


N/A
·

Unable to perform DTC judgment

·

Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit



If the judgment result shows INCOMPLETE or N/A, perfrom the DTC comfirmation driving pattern again.


l.

Turn the power switch off.



CHECK FOR DIAGNOSIS RELATED INFORMATION


HINT:

Clearing the DTCs will also clear the diagnosis related information.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Hybrid Control / Utility / Diagnosis Related Information.

Powertrain > Hybrid Control > Utility
Tester Display
Diagnosis Related Information
50005 397 1056

e.

Check the diagnosis related information and freeze frame data, and then write them down.



CLEAR DIAGNOSIS RELATED INFORMATION


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Hybrid Control / Clear DTCs.

Powertrain > Hybrid Control > Clear DTCs
50002 397

e.

Clear the diagnosis related information and freeze frame data.