Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0244228 LIGHTING SYSTEM D

LIGHTING (EXT)  LIGHTING SYSTEM  INITIALIZATION  


NOTICE:
·

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 headlight ECU sub-assembly LH removal/installation are shown below.

Performed Work or System Condition Necessary Procedures Link
Replacement of the No. 1 headlight ECU sub-assembly LH Synchronize the vehicle information (Click here)
Perform No. 1 headlight ECU sub-assembly LH initialization
Replacement of the rear height control sensor RR LH, removal and reinstallation of the rear height control sensor RR LH, replacement of the suspension, etc. have been performed Perform No. 1 headlight ECU sub-assembly LH initialization

·

A new No. 1 headlight ECU sub-assembly LH cannot operate until the vehicle information is registered.

·

After replacing the No. 1 headlight ECU sub-assembly LH, it is necessary to perform vehicle information registration and initialization.

·

Even if the No. 1 headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.