Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0244228 LIGHTING SYSTEM U

LIGHTING (EXT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body, Combination Meter, HL AutoLeveling / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Parking Brake SW Parking brake switch signal ON or OFF ON: Parking brake switch on
OFF: Parking brake switch off
-
Dimmer SW Dimmer switch high position signal ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position
-
Passing Light SW Dimmer switch high flash position (pass) signal ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position
-
Rear Fog Light SW Fog light switch rear position signal ON or OFF ON: Fog light switch in rear position
OFF: Fog light switch off
*1
Front Fog Light SW Fog light switch front position signal ON or OFF ON: Fog light switch in front position
OFF: Fog light switch off
-
Auto Light SW Light control switch AUTO position signal ON or OFF ON: Light control switch in AUTO position
OFF: Light control switch not in AUTO position
-
Head Light SW (Head) Light control switch head position signal ON or OFF ON: Light control switch in head position
OFF: Light control switch not in head position
-
Head Light SW (Tail) Light control switch tail position signal ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch not in tail or head position
-
Light Sensor Illuminance Light control sensor illuminance 0 to 8191 lx Value is output according to ambient light level -
Headlight Lighting Function ECU which controls the lighting system Main Body or Lighting Sys ECU Main Body: Lighting system controlled by main body ECU (multiplex network body ECU)
Lighting Sys ECU: Lighting system is controlled by headlight ECU sub-assembly
-
Response Time Delay timing of lighting the taillights when the automatic light control sensor detects brightness change Normal or Long Customize setting displayed *3
Sensitivity Sensitivity of the automatic light control system Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
Disp Ex ON Sen Ambient brightness level required to dim display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
Disp Ex OFF Sen Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.) Light2, Light1, Normal, Dark1 or Dark2 Customize setting displayed -
Light Auto OFF Delay Light auto OFF delay Off, 30 s, 60 s, or 90 s Customize setting displayed *4
Follow Me Home Lighting Time Follow me home lighting time 30 s, 60 s, 90 s or 120 s Customize setting displayed *2
The Number of DTC Number of trouble codes 0 to 255 Number of stored DTCs displayed -

*1: w/ Rear Fog Light

*2: w/ Follow Me Home System

*3: for vehicle with customize setting "Response Time"

*4: for vehicle with customize setting "Light Auto OFF Delay"


Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Turn Signal Switch (Right) Turn signal switch (right) signal ON or OFF ON: Turn signal switch (right) on
OFF: Turn signal switch (right) off
-
Turn Signal Switch (Left) Turn signal switch (left) signal ON or OFF ON: Turn signal switch (left) on
OFF: Turn signal switch (left) off
-
Hazard Flasher Switch Hazard warning signal switch signal ON or OFF ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off
-
Turn Switch Signal (Full Turn) Turn signal switch (full turn) signal ON or OFF ON: Turn signal switch (left or right) on
OFF: Turn signal switch (left and right) off
-
Lane Change Flashing Times Setting Setting of lane change flashing times OFF, 3, 4, 5, 6, 7 Customize setting displayed -
Body Electrical > HL AutoLeveling > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Headlight Low Beam State Low beam headlight state ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off
-
Headlight High Beam State High beam headlight state ON or OFF ON: High beam headlights on
OFF: High beam headlights off
-
DRL Operating State Daytime running light state ON or OFF ON: Daytime running lights on
OFF: Daytime running lights off
-
Clearance Light State Clearance light state ON or OFF ON: Clearance lights on
OFF: Clearance lights off
-
+B No. 1 headlight ECU sub-assembly LH IG power supply voltage value 0 to 19.75 V 11.00 to 14.00 V -
Height Sens Pw Supply Val Rear height control sensor RR LH power supply value 0 to 5.00 V 4.61 to 5.00 V -
Rr Height Sens Signal Val Rear height control sensor RR LH signal value 0 to 5.00 V 0.50 to 4.50 V -
Front Right Wheel Speed Value Front right wheel speed 0.00 to 260.00 km/h (162.00 mph) Vehicle stopped: 0 km/h (0 mph) -
Front Left Wheel Speed Value Front left wheel speed 0.00 to 260.00 km/h (162.00 mph) Vehicle stopped: 0 km/h (0 mph) -
Vehicle Speed Vehicle speed 0.00 to 260.00 km/h (162.00 mph) Vehicle stopped: 0 km/h (0 mph) -
Rear Height Adjust Value Rear height adjustment off set value 0 to 1023 Actual rear height adjustment normal value is displayed (If there is a malfunction, no value is displayed) -
Rear Height Adjust Valid Flag Rear height adjustment range Valid or Invalid Valid: Rear height control sensor RR LH value within normal range
Invalid: Rear height control sensor RR LH value out of normal range
-
Init Writing Count Number of times initialization performed 0 to 255 Number of times initialization performed -
Sensor Initialization Hist Sensor initialization history not comp, 10%, 25%, 50%, 75%, 100% or completed
·

not comp: No. 1 headlight ECU sub-assembly LH not initialized after replacing.

·

10%: Initialization completed when fuel tank was 10% full

·

25%: Initialization completed when fuel tank was 25% full

·

50%: Initialization completed when fuel tank was 50% full

·

75%: Initialization completed when fuel tank was 75% full

·

100%: Initialization completed when fuel tank was 100% full

·

completed: ECU not replaced and ECU has not been initialized at workshop.


-
Steering Sensor Signal Steering sensor value -384 to 382.5 deg 0.0 deg -
Steering Sensor Center Position Steering sensor center position -3072 to 3070.5 deg 0.0 deg -
+B Voltage Value No. 1 headlight ECU sub-assembly LH power supply voltage value 0 to 19.75 V 11.00 to 14.00 V -
Leveling Motor Target Position Headlight leveling motor target position 0 to 102.3% 10 to 90% -
Number Of Trouble Codes Number of trouble codes 0 to 255 Number of stored DTCs displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main body, HL AutoLeveling / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Daytime Running Light Daytime running lights ON or OFF -
Taillight Relay Taillight relay ON or OFF -
Headlight Relay Low beam headlights ON or OFF -
Head Light Hi High beam headlights ON or OFF -
Front Fog Light Relay Front fog lights ON or OFF Light control switch in tail position
Rear Fog Light Relay Rear fog lights ON or OFF Light control switch in tail position*

*: w/ Rear Fog Light


Body Electrical > HL AutoLeveling > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Clearance Light Clearance lights ON or OFF -
Headlight Low Beam Low beam headlights ON or OFF -
Headlight High Beam High beam headlights ON or OFF -
Daytime Running Light Daytime running lights ON or OFF -
Headlight Indicator "Headlight System Malfunction Visit Your Dealer" display ON or OFF -