These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0073 | Control Module Communication Bus OFF | Lost communication with CAN communication line | CAN communication system | - |
| U0100 | Lost Communication with ECM / PCM "A" | Lost communication with ECM assembly | ·
CAN communication system ·
ECM assembly |
- |
| U0101 | Lost Communication with TCM | Lost communication with TCM | ·
CAN communication system ·
Hybrid vehicle control ECU assembly |
- |
| U0126 | Lost Communication with Steering Angle Sensor Module | Lost communication with steering sensor | ·
CAN communication system ·
Steering sensor |
- |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU assembly | ·
CAN communication system ·
Skid control ECU assembly |
- |
| U0142 | Lost Communication with Body Control Module "B" | Lost communication with main body ECU (multiplex network body ECU) | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) |
- |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | Lost communication with combination meter assembly | ·
CAN communication system ·
Combination meter assembly |
- |
| U0293 | Lost Communication with Hybrid Vehicle Control System | Lost communication with hybrid vehicle control ECU assembly | ·
CAN communication system ·
Hybrid vehicle control ECU assembly |
- |
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING