Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0244229 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM D

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

Automatic headlight beam level control system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and perform repairs.




INSPECT AUXILIARY BATTERY VOLTAGE


a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery.



DIAGNOSIS SYSTEM


a.

If the automatic headlight beam level control system malfunctions, "Headlight System Malfunction Visit Your Dealer" warning message is displayed on the multi-information display.

HINT:

In this case, the No. 1 headlight ECU sub-assembly LH stores DTCs.

Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR