Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY SWITCH
RM3210E _58 Vehicle Interior _047509 METER / GAUGE / DISPLAY _0232400 HEADUP DISPLAY SWITCH G

METER / GAUGE / DISPLAY  HEADUP DISPLAY SWITCH  INSPECTION  


PROCEDURE

Hide 84970E 1.INSPECT HEADUP DISPLAY SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY)

a.
E338795C03
1.292,0.813 1.542,0.344 false 1.792,2.385 2,1.906 false 1.49,3.073 1.635,2.708 false 0.844,1.771 1.156,1.927 0.313,0.156 10 false *a 1.521,0.198 1.833,0.354 0.313,0.156 10 false *1 1.448,3.104 1.76,3.26 0.313,0.156 10 false E 1.948,1.74 2.26,1.896 0.313,0.156 10 false ILU
*1 Headup Display Switch
*a Component without harness connected
(Headup Display Switch (No. 2 Combination Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (ILU) - 10 (E) Headup display switch pressed Below 1 Ω
Headup display switch not pressed 10 kΩ or higher


If the result is not as specified, replace the headup display switch (No. 2 combination switch assembly).


b.
E338795C04
1.927,2.385 2.135,1.906 false 1.198,3.073 1.344,2.708 false 1.313,0.813 1.573,0.375 false 0.844,1.771 1.156,1.927 0.313,0.156 10 false *a 1.094,3.083 1.406,3.24 0.313,0.156 10 false ILL+ 2.052,1.74 2.365,1.896 0.313,0.156 10 false ILL- 1.563,0.229 1.875,0.385 0.313,0.156 10 false *1
*1 Headup Display Switch
*a Component without harness connected
(Headup Display Switch (No. 2 Combination Switch Assembly))


Illumination Inspection

i.

Apply auxiliary battery voltage to the headup display switch (No. 2 combination switch assembly) and check that it illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 12 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the headup display switch (No. 2 combination switch assembly).