Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM3210E _59 Vehicle Exterior _047530 SLIDING ROOF / CONVERTIBLE _0244347 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  DISASSEMBLY  


PROCEDURE

Hide 63260A 1.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

a.
B432077C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the bolt.


b.

Disengage the 2 guides as shown in the illustration to remove the map light bracket.


c.
B432079

Remove the 2 bolts and sliding roof drive gear sub-assembly.


Hide 63306 2.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

a.
B432080C01
1.198,0.813 1.354,1.01 0.156,0.198 10 false A 2.281,0.365 2.406,0.531 0.125,0.167 10 true B 2.646,0.719 2.771,0.885 0.125,0.167 10 true B
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Remove the screw.


b.

Move the sliding roof piece sub-assembly LH in the direction indicated by the arrow (1) shown in the illustration to disengage the guide (A).


c.

Move the sliding roof piece sub-assembly LH in the direction indicated by the arrow (2) shown in the illustration to disengage the 2 guides (B) and remove the sliding roof piece sub-assembly LH.

HINT:

Use the same procedure for the RH side.



d.
B432087C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear sliding roof sunshade stopper as shown in the illustration.

HINT:

Use the same procedure for the RH side.



e.
B432083C01
0,0 0,0 false
V113147

Remove in this Direction


Slide and remove the sunshade trim sub-assembly as shown in the illustration.


Hide 63205A 3.REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:

Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


a.

Using a screwdriver, disengage the 2 claws as shown in the illustration.

B432098C01
0.354,0.573 0.708,0.719 true 6.51,1.438 6.833,1.323 true 0.198,0.5 0.385,0.656 0.188,0.156 10 false *a 6.865,1.25 7.052,1.406 0.188,0.156 10 false *a
*a Protective Tape - -
V113147

Remove in this Direction - -


HINT:

Tape the screwdriver tip before use.



b.
B432088C01
0,0 0,0 false
V113147

Remove in this Direction


Slide and remove the rear roof drip channel as shown in the illustration.


c.
B432093C01
0,0 0,0 false
V113146

Hold Position


Hold down the roof wind deflector panel sub-assembly.


d.
B432101C01
1.438,4.021 1.552,3.615 true 1.375,4.031 1.688,4.188 0.313,0.156 10 false *a
*a Protective Tape
V113146

Push Position
V113147

Remove in this Direction


Using a screwdriver, slide the sliding roof drive cable LH as shown in the illustration to remove it.

HINT:
·

Tape the screwdriver tip before use.

·

Use the same procedure for the RH side.