Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0244350 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Measure the resistance according to the value(s) in the table below.

E344390C01
1.417,2.583 1.583,3 true 0.781,2.583 0.615,3 true 0.479,3.01 0.938,3.208 0.458,0.198 10 false CCS 1.458,3.021 1.917,3.219 0.458,0.198 10 false ECC 2.583,2.083 3.125,2.365 0.542,0.281 10 false (ECC) 5.75,3.25 6.292,3.531 0.542,0.281 10 false (CCS) 5.469,2.5 6.083,2.698 0.615,0.198 10 false MAIN 4.729,2.5 5.396,2.75 0.667,0.25 10 false +RES 4.042,2.5 4.708,2.75 0.667,0.25 10 false -SET 3.104,2.5 4.021,2.917 0.917,0.417 10 false CANCEL
*a Component without harness connected
(Cruise Control Switch)
- -


Standard Resistance:
Tester Connection Condition Specified Condition
1 (ECC) - 3 (CCS) Cruise control switch (ON-OFF button) released 1 MΩ or higher
Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
+/RES 236 to 244 Ω
-/SET 618 to 642 Ω
CANCEL 1510 to 1570 Ω


i.

If the result is not as specified, replace the cruise control main switch.