Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM3210E _59 Vehicle Exterior _047505 DOOR / HATCH _0244377 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68960B 1.REMOVE BACK DOOR STAY ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



a.
B435639C02
0.531,0.958 0.906,1.156 true 2.781,2.542 3.021,2.667 true 0.927,1.073 1.125,1.25 0.198,0.177 10 true *a 3.042,2.583 3.24,2.76 0.198,0.177 10 true *a
*a Protective Tape
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Using a screwdriver with its tip wrapped with protective tape, slightly raise the 2 stop rings as indicated by the arrows, in the order shown in the illustration.

NOTICE:
·

Do not remove the stop rings from the back door stay assembly. Raise the stop rings just enough to allow the ball joints to be disengaged.

·

Do not reuse the back door stay assembly if a stop ring has been removed.




b.

Disengage the 2 ball joints to remove the back door stay assembly.

NOTICE:

Remove the back door stay assembly while supporting the back door by hand.



Hide 68946 2.REMOVE BACK DOOR DAMPER STAY UPPER BRACKET

a.
B435640

Remove the 2 bolts and back door damper stay upper bracket.


Hide 68961 3.REMOVE BACK DOOR STAY BOLT

a.
B435641

Remove the back door stay bolt.