Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM3210E _59 Vehicle Exterior _047505 DOOR / HATCH _0244377 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68961 1.INSTALL BACK DOOR STAY BOLT

a.

Clean the bolt hole on the back door.


b.

Apply adhesive to the threads of the back door stay bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door stay bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)


Hide 68946 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET

a.

Clean the 2 bolt holes on the vehicle body.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay upper bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68960B 3.INSTALL BACK DOOR STAY ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



a.
B435642

Engage the 2 ball joints to install the back door stay assembly.

NOTICE:

Install the back door stay assembly while supporting the back door by hand.



b.

Check that the ball joints are engaged securely and the back door stay assembly cannot be pulled off.