Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
87945
2.REMOVE OUTER MIRROR COVER
87948
3.REMOVE OUTER MIRROR HOLE COVER
Disengage the 5 claws and guide to remove the outer mirror hole cover.
81740
4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
8794A
5.REMOVE NO. 2 OUTER MIRROR COVER
Disengage the 2 claws and guide to remove the No. 2 outer mirror cover.
87966
6.REMOVE OUTER MIRROR RETRACTOR
| *a | Cut here |
Cut the wire harness sub-assembly at the position shown in the illustration.
Disengage the 3 guides and remove the gasket sub-assembly.
Make sure to replace the gasket sub-assembly with a new one.
Disengage the 5 claws and guide to remove the lower cover.
Using a T25 "TORX" socket wrench, remove the 3 screws and base sub-assembly.
Remove the 3 screws.
Disconnect the connector.
Disengage the 2 clamps.
Disconnect the connector to remove the actuator sub-assembly.
|
Remove in this Direction |
Pull the wire harness sub-assembly through the frame sub-assembly as shown in the illustration to remove the wire harness sub-assembly.
Make sure to replace the wire harness sub-assembly with a new one.
Remove the 2 screws.
Remove the 2 screws and frame sub-assembly from the housing.
Make sure to replace the frame sub-assembly with a new one.