Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER MOTOR ASSEMBLY
RM3210E _59 Vehicle Exterior _047505 DOOR / HATCH _0244385 FUEL LID OPENER MOTOR ASSEMBLY G

DOOR / HATCH  FUEL LID OPENER MOTOR ASSEMBLY  INSPECTION  


PROCEDURE

Hide 77030A 1.INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY

a.

Check the operation of the fuel lid lock with motor assembly (motor operation).

i.
B429573C04
1.177,1.802 1.042,1.802 1.042,1.802 0.875,1.177 false 0.99,1.979 1.302,2.177 0.313,0.198 10 false *a 2.948,1.427 3.26,1.625 0.313,0.198 10 false *b 2.719,1.427 3.031,1.625 0.313,0.198 10 false *d 3.156,1.417 3.427,1.615 0.271,0.198 10 false *c 1.219,1.729 1.531,1.927 0.313,0.198 10 false *e
*a Component without harness connected
(Fuel Lid Lock with Motor Assembly)
*b Shaft Stroke
*c Shaft not pushed
*d Shaft Pushed
*e Lever


Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and measure the shaft stroke.

OK:
Auxiliary Battery Connection Specified Condition
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 2
16.80 mm
(0.661 in.)


If the result is not as specified, replace the fuel lid lock with motor assembly.



b.

Check the operation of the fuel lid lock with motor assembly (fuel lid courtesy switch). (w/ Canister Pump Module)

i.

Measure the resistance according the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Shaft not pushed (ON)
(Shaft stroke is below 0.73 mm (0.029 in.).)
Below 1 Ω
2 - 3 Shaft pushed (OFF)
(Shaft stroke is more than 0.73 mm (0.029 in.).)
10 kΩ or higher


If the result is not as specified, replace the fuel lid lock with motor assembly.



c.

Measure the shaft stroke.

OK:
Area Condition Specified Condition
Shaft stroke Lever pulled 16.80 mm
(0.661 in.)


If the result is not as specified, replace the fuel lid lock with motor assembly.