Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0241783 CRANKSHAFT POSITION SENSOR A

2ZR-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 11401G 1.REMOVE CRANKSHAFT POSITION SENSOR

a.
A375022

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.