Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0241783 CRANKSHAFT POSITION SENSOR A

2ZR-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the crankshaft position sensor, check the O-ring.



b.

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Make sure that the O-ring is not cracked or moved out of place when installing crankshaft position sensor.

·

If the crankshaft position sensor has been struck or dropped, replace it.




c.

Connect the crankshaft position sensor connector.