Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0244634 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  IG Power Source Circuit  


DESCRIPTION

Power source voltage is supplied to the air conditioning amplifier assembly when the power switch is turned on (IG). This power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E290891E21
5.469,3.625 7.031,4.135 1.563,0.51 10 false Air Conditioning Amplifier Assembly 5.479,3.458 5.854,3.656 0.375,0.198 10 false F58 6.052,2.208 6.427,2.406 0.375,0.198 10 false GND 6.052,0.917 6.427,1.115 0.375,0.198 10 false IG+ 4.448,1.073 5.469,1.281 1.021,0.208 10 false ECU-IG1 NO. 4 5.865,0.813 6.063,1.01 0.198,0.198 10 false 2 5.875,2.073 6.094,2.271 0.219,0.198 10 false 4 0.354,0.917 2.083,1.177 1.729,0.26 10 false from Auxiliary Battery 0.646,1.552 1.729,2.167 1.083,0.615 10 false from Certification ECU (Smart Key ECU Assembly) 3.177,1.865 3.958,2.177 0.781,0.313 10 false IG1-NO. 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the F58 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F58-2 (IG+) - Body ground Power switch off Below 1 V
F58-2 (IG+) - Body ground Power switch on (IG) 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F58-4 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR