AIR CONDITIONING AMPLIFIER ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F57-1 (SG-1) - Body ground | LG - Body ground | Ground for cooler (room temp. sensor) thermistor | Always | Below 1 V |
| F57-2 (SG-2) - Body ground | P - Body ground | Ground for thermistor assembly, air conditioner pressure sensor | Always | Below 1 V |
| F57-6 (S5-3) - F57-2 (SG-2) | GR - P | Power supply for air conditioner pressure sensor | Power switch on (IG) | 4.75 to 5.25 V |
| Power switch off | Below 1 V | |||
| F57-10 (PTC2) - F58-4 (GND)*1 | R - W-B | Quick heater assembly operation signal | ·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: 16°C (61°F) or lower ·
Engine coolant temperature: 70°C (158°F) or lower ·
Light control switch off ·
Blower switch: On |
Below 1 V |
·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: 16°C (61°F) or lower ·
Engine coolant temperature: 70°C (158°F) or lower ·
Light control switch off ·
Blower switch: Off |
11 to 15.5 V | |||
| F57-11 (PTC3) - F58-4 (GND)*1 | BR - W-B | Quick heater assembly operation signal | ·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: -7°C (19°F) or lower ·
Engine coolant temperature: 65°C (149°F) or lower ·
Light control switch off ·
Blower switch: On |
Below 1 V |
·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: -7°C (19°F) or lower ·
Engine coolant temperature: 65°C (149°F) or lower ·
Light control switch off ·
Blower switch: Off |
11 to 15.5 V | |||
| F57-13 (TAM) - F57-2 (SG-2) | BE - P | Thermistor assembly signal | ·
Power switch on (IG) ·
Ambient temperature: 25°C (77°F) |
1.35 to 1.75 V |
·
Power switch on (IG) ·
Ambient temperature: 40°C (104°F) |
0.9 to 1.2 V | |||
| F57-14 (TR) - F57-1 (SG-1) | B - LG | Cooler (room temp. sensor) thermistor signal | ·
Power switch on (IG) ·
Cabin temperature: 25°C (77°F) |
1.8 to 2.2 V |
·
Power switch on (IG) ·
Cabin temperature: 40°C (104°F) |
1.2 to 1.6 V | |||
| F57-24 (PRE) - F57-2 (SG-2) | SB - BE | Air conditioner pressure sensor signal | ·
Power switch on (READY) ·
Air conditioning system operating ·
Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.8 kgf/cm2, 439 psi)) |
4.61 V or higher |
·
Power switch on (READY) ·
Air conditioning system operating ·
Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 26 psi)) |
Below 0.74 V | |||
·
Power switch on (READY) ·
Air conditioning system operating ·
Refrigerant pressure: Normal pressure (less than 3025 kPa (30.8 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 26 psi)) |
0.74 to 4.61 V | |||
| F57-26 (SHIN) - F58-4 (GND)*2 | R - W-B | Seat heater switch signal | ·
Power switch on (IG) ·
Seat heater switch (for driver side) off |
11 to 14 V |
·
Power switch on (IG) ·
Seat heater switch (for driver side) on |
Below 1 V | |||
| F58-1 (B) - F58-4 (GND) | V - W-B | Power source (Back-up) | Power switch off | 11 to 14 V |
| F58-2 (IG+) - F58-4 (GND) | B - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| F58-4 (GND) - Body ground | W-B - Body ground | Ground for main power supply | Always | Below 1 V |
| F58-6 (BLW) - F58-4 (GND) | SB - W-B | Blower motor speed control signal | ·
Power switch on (IG) ·
Blower switch: LO |
Pulse generation
(See waveform 1) |
| F58-11 (CANH) - F58-12 (CANL) | BE - W | CAN communication signal | CAN communication is performed | Pulse generation |
| F58-14 (LIN1) - F58-4 (GND) | BE - W-B | LIN communication signal (Air conditioning control assembly) | Power switch on (IG) | Pulse generation
(See waveform 2) |
| F58-15 (SCLI) - F58-4 (GND) | G - W-B | LIN communication signal (Air conditioning thermistor assembly, windshield wiper relay assembly*3) | Power switch on (IG) | Pulse generation |
| F58-18 (PTC1) - F58-4 (GND)*1 | G - W-B | Quick heater assembly operation signal | ·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: 25°C (77°F) or lower ·
Engine coolant temperature: 75°C (167°F) or lower ·
Light control switch off ·
Blower switch: On |
Below 1 V |
·
Power switch on (READY) ·
ECO mode: Off ·
Temperature setting: MAX HOT ·
Ambient temperature: 25°C (77°F) or lower ·
Engine coolant temperature: 75°C (167°F) or lower ·
Light control switch off ·
Blower switch: Off |
11 to 15.5 V | |||
| z1-2 (BUS G) - Body ground | - | Ground for BUS IC | Always | Below 1 V |
| z1-3 (BUS) - z1-2 (BUS G) | - | BUS IC control signal | Power switch on (IG) | Pulse generation
(See waveform 3) |
| z1-4 (B BUS) - z1-2 (BUS G) | - | Power supply for BUS IC | Power switch off | 11 to 14 V |
| z1-5 (SGA) - Body ground | - | Ground for No. 1 cooler thermistor | Always | Below 1 V |
| z1-6 (TEA) - z1-5 (SGA) | - | No. 1 cooler thermistor signal | ·
Power switch on (IG) ·
Evaporator temperature: 0°C (32°F) |
1.7 to 2.1 V |
·
Power switch on (IG) ·
Evaporator temperature: 15°C (59°F) |
0.9 to 1.3 V |
*1: w/ PTC Heater
*2: w/ Seat Heater System
*3: w/ Auto Wiper System
Waveform 1:
| Item | Content |
|---|---|
| Terminal No. | F58-6 (BLW) - F58-4 (GND) |
| Tool Setting | 2 V/DIV., 1 ms./DIV. |
| Vehicle Condition | ·
Power switch on (IG) ·
Blower switch: LO |
Waveform 2:
| Item | Content |
|---|---|
| Terminal No. | F58-14 (LIN1) - F58-4 (GND) |
| Tool Setting | 2 V/DIV., 20 ms./DIV. |
| Vehicle Condition | Power switch on (IG) |
Waveform 3:
| Item | Content |
|---|---|
| Terminal No. | z1-3 (BUS) - z1-2 (BUS G) |
| Tool Setting | 2 V/DIV., 2 ms./DIV. |
| Vehicle Condition | Power switch on (IG) |
AIR CONDITIONING CONTROL ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning control assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F52-1 (GND) - Body ground | W-B - Body ground | Ground for air conditioning control assembly | Always | Below 1 V |
| F52-4 (ILL+) - Body ground | W - Body ground | Illumination signal | Light control switch off | Below 1 V |
| Light control switch in tail or head position | 11 to 14 V | |||
| F52-5 (ILL-) - Body ground | V - Body ground | Illumination signal | Always | Below 1 V |
| F52-6 (LIN1) - Body ground | BE - Body ground | LIN communication signal | Power switch on (IG) | Pulse generation |
| F52-8 (IG+) - F52-1 (GND) | LG - W-B | Power source (IG) | Power switch off | Below 1 V |
| Power switch on (IG) | 11 to 14 V |
HYBRID VEHICLE CONTROL ECU
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>TERMINALS OF ECU