The air conditioning amplifier assembly and air conditioning thermistor assembly communicate via LIN communication.
The air conditioning amplifier assembly stores this DTC if communication becomes abnormal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B1279 | Lost Communication with Humidity/Rain Sensor LIN | Lost communication with air conditioning thermistor assembly | ·
Harness or connector between air conditioning thermistor assembly and IG power source ·
Harness or connector between air conditioning thermistor assembly and body ground ·
LIN communication system ·
Air conditioning amplifier assembly ·
Air conditioning thermistor assembly |
Memorized
(10 sec. or more)* |
*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following procedure.
The air conditioning thermistor assembly must be replaced if the glass temperature sensor is malfunctioning.
Check for DTCs.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B1373 is output | A |
| DTC B1373 is not output | B |
A
B
Disconnect the O1 air conditioning thermistor assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O1-4 (SIG) - Body ground | Power switch on (IG) | 11 to 14 V |
| O1-4 (SIG) - Body ground | Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O1-2 (ES) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F58 air conditioning amplifier assembly connector.
Disconnect the F43 windshield wiper relay assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O1-3 (MPX) - F58-15 (SCLI) | Always | Below 1 Ω |
| O1-3 (MPX) or F58-15 (SCLI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG