Home › Brake › BRAKE (REAR) › REAR BRAKE
RM3210E _54 Brake _047537 BRAKE (REAR) _0244653 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


PROCEDURE

Hide 47831 1.REMOVE REAR DISC BRAKE PISTON

a.
C345978N03
1.292,1.865 2,1.865 true 2.042,1.802 2.5,2 0.458,0.198 10 false SST

Using SST, remove the rear disc brake piston by turning it counterclockwise.

SST
09719-12010  (09719-01030)

NOTICE:
·

Do not damage the rear disc brake piston.

·

Do not allow any brake fluid to spatter.




Hide 2.REMOVE CYLINDER BOOT

a.

Remove the cylinder boot from the rear disc brake cylinder.


Hide 3.REMOVE PISTON SEAL

a.
C116888C05
1.521,0.948 1.198,0.302 1.198,0.302 0.948,0.302 true 0.76,0.24 1.042,0.458 0.281,0.219 10 *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder.

NOTICE:

Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.



Hide 31478C 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

Hide 47547C 5.REMOVE REAR DISC BRAKE BLEEDER PLUG