Home › Brake › BRAKE (REAR) › REAR BRAKE
RM3210E _54 Brake _047537 BRAKE (REAR) _0244653 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547C 1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

HINT:

Fully tighten the rear disc brake bleeder plug after bleeding the system.


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C211755C04
1.365,1.25 1.354,1.26 false
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.


b.

Install the piston seal to the rear disc brake cylinder.

NOTICE:

Securely install the piston seal to the groove of the rear disc brake cylinder.



Hide 4.INSTALL CYLINDER BOOT

a.
C227813C02
2.344,2.688 2.469,2.688 false
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of the rear disc brake piston and a new cylinder boot.


b.

Install the cylinder boot to the rear disc brake piston as shown in the illustration.

NOTICE:

Do not install the cylinder boot after installing the piston into the disc brake cylinder.



Hide 47831 5.INSTALL REAR DISC BRAKE PISTON

a.
C108956

Install the seal portion of the cylinder boot into the groove portion of the rear disc brake cylinder.

NOTICE:

Securely install the cylinder boot to the groove of the rear disc brake cylinder.



b.
C345978N04
1.292,1.865 2,1.865 true 2.042,1.802 2.5,2 0.458,0.198 10 false SST

Using SST, install the rear disc brake piston by turning it clockwise as far as possible.

SST
09719-12010  (09719-01030)

NOTICE:
·

Securely install the cylinder boot to the groove of the rear disc brake piston.

·

Do not damage the rear disc brake piston or cylinder boot.




c.
C176440N03
1.083,0.458 1.365,0.667 0.281,0.208 10 true 90°

Using SST, slowly return the piston until the piston groove is positioned as shown in the illustration.

HINT:

When installing the rear disc brake cylinder assembly to the rear disc brake cylinder mounting, align the piston groove with the protrusion on the rear disc brake pad.



d.
C345982C02
2.813,1.094 2.635,1.094 2.635,1.094 2.635,0.948 false 2.844,1.01 3.156,1.167 0.313,0.156 10 false *1
*1 Cylinder Boot


Make sure that the cylinder boot is securely installed into the groove of the rear disc brake cylinder and rear disc brake piston.