Home › General › SPECIFICATIONS › HYBRID / BATTERY CONTROL
RM3210E _V1 General _047544 SPECIFICATIONS _0224699 HYBRID / BATTERY CONTROL F

SPECIFICATIONS  HYBRID / BATTERY CONTROL  SERVICE DATA  


Reserve Tank Cap (for Inverter)
Item Specified Condition
Standard Value (for Brand-new Cap) 94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 18 psi)
Minimum Standard Value (for Used Cap) 94 kPa (1.0 kgf/cm2, 13.6 psi)

Relay
Item Tester Connection Specified Condition
IGCT relay (IGCT)
Resistance
3 - 5 10 kΩ or higher
(Auxiliary battery voltage not applied across terminals 1 and 2)
Below 1 Ω
(Auxiliary battery voltage applied across terminals 1 and 2)

HV Battery Junction Block Assembly
SMRB
Resistance
S4-1 (CBI) - A-1 (+) 10 kΩ or higher
(Auxiliary battery voltage is not applied between terminals M37-1 (SMRB) and M37-3 (GND))
Below 1 Ω
(Auxiliary battery voltage applied between terminals M37-1 (SMRB) and M37-3 (GND))
M37-1 (SMRB) - M37-3 (GND) 20.6 to 40.8 Ω at -40 to 80°C (-40 to 176°F)
SMRG
Resistance
S3-1 (CEI) - z19-1 (-) 10 kΩ or higher
(Auxiliary battery voltage not applied between terminals M37-4 (SMRG) and M37-3 (GND))
Below 1 Ω
(Auxiliary battery voltage applied between terminals M37-4 (SMRG) and M37-3 (GND))
M37-4 (SMRG) - M37-3 (GND) 20.6 to 40.8 Ω at -40 to 80°C (-40 to 176°F)
SMRP
Resistance
S3-1 (CEI) - z19-1 (-) 10 kΩ or higher
(Auxiliary battery voltage applied between terminals M37-2 (SMRP) and M37-3 (GND))
24.3 to 29.7 Ω
(Auxiliary battery voltage applied between terminals M37-2 (SMRP) and M37-3 (GND))
M37-2 (SMRP) - M37-3 (GND) 140 to 290 Ω at -40 to 80°C (-40 to 176°F)

Pattern Select Switch Assembly (for LHD)
Pattern Select Switch Assembly
Resistance
10 (S) - 9 (E) Below 50 Ω
(EV mode switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(EV mode switch (pattern select switch assembly) not pushed)
3 (DRV) - 9 (E) Below 50 Ω
(DRIVE mode switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(DRIVE mode switch (pattern select switch assembly) not pushed)
6 (IG) - 14 (ECU)
(w/ Vehicle Proximity Notification System)
Below 50 Ω
(VAS OFF switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(VAS OFF switch (pattern select switch assembly) not pushed)
Battery positive (+) → 13 (ILL+)
Battery negative (-) → 2 (ILL-)
Illuminates

Pattern Select Switch Assembly (for RHD)
Pattern Select Switch Assembly
Resistance
3 (S) - 9 (E) Below 50 Ω
(EV mode switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(EV mode switch (pattern select switch assembly) not pushed)
10 (DRV) - 9 (E) Below 50 Ω
(DRIVE mode switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(DRIVE mode switch (pattern select switch assembly) not pushed)
Battery positive (+) → 13 (ILL+)
Battery negative (-) → 2 (ILL-)
Illuminates

Service Plug Grip
Service plug grip - Below 1 Ω

Hybrid Battery Terminal Block
Hybrid Battery Terminal Block - Below 1 Ω

COOLANT
Identification Mark Capacity Classification
R1 1.4 liters (1.5 US qts, 1.2 Imp. qts) Use only "TOYOTA Super Long Life Coolant" or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids).
R2 1.5 liters (1.6 US qts, 1.3 Imp. qts)