Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING FILTER
RM3210E _51 Engine / Hybrid System _047524 HYBRID / BATTERY CONTROL _0244779 BATTERY COOLING FILTER A

HYBRID / BATTERY CONTROL  BATTERY COOLING FILTER  INSTALLATION  


PROCEDURE

Hide G92DH 1.INSTALL NO. 1 HV BATTERY INTAKE FILTER

a.

Engage the 2 claws to temporarily install the No. 1 HV battery intake filter to the battery service hole cover.


b.

Engage the claw to install the No. 1 HV battery intake filter to the battery service hole cover.


Hide 58441E 2.INSTALL BATTERY SERVICE HOLE COVER

a.

Engage the 5 claws to install the battery service hole cover.


b.

Install the clip.


Hide 3. CLEAR DTC

HINT:

If the message "Maintenance Required for Hybrid Battery Cooling Parts at Your Dealer" is displayed on the multi-information display, clean or replace the No. 1 HV battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR