Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244855 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E227013E27
0.385,0.688 1.938,0.875 1.552,0.188 10 false from IG1 NO. 1 Relay 2.417,0.948 3.427,1.115 1.01,0.167 10 false ECU-IG1 NO. 4 5.313,0.573 5.51,0.74 0.198,0.167 10 false 1 5.25,1.354 5.427,1.521 0.177,0.167 10 false 30 5.5,0.688 5.719,0.906 0.219,0.219 10 false IG 5.5,1.469 5.656,1.646 0.156,0.177 10 false E 5.083,1.927 5.427,2.104 0.344,0.177 10 false F26 5.083,2.083 6.615,2.406 1.531,0.323 10 false Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)
a.

Disconnect the F26 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F26-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
F26-1 (IG) - Body ground Power switch off Below 1 V



Result:
Result Proceed to
OK A
NG B



A

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

B

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F26-30 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR