Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244874 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM U

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > IPA/ICS/Clearance Sonar > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
IPA Avoidance Distance Simple intelligent parking assist avoidance distance setting Short, Standard, Long or Max The selected customized value is displayed -
IPA Perpendicular Parking Control Area Simple intelligent parking assist perpendicular parking range setting Small, Middle, Large or Max The selected customized value is displayed -
IPA Parallel Parking Control Area Simple intelligent parking assist parallel parking range setting Small, Middle, Large or Max The selected customized value is displayed -
IPA System Existence of simple intelligent parking assist system Without, With or Unfixed Without: w/o Simple intelligent Parking Assist System
With: w/ Simple intelligent Parking Assist System
Unfixed: Unknown
-
IPA Switch S-IPA switch signal OFF or ON ON: S-IPA switch on
OFF: S-IPA switch off
-
Side Sensor Alarm Function Side sensor alarm function OFF or ON ON: Side sensor alarm function on
OFF: Side sensor alarm function off
-
Bumper Type Registered bumper type Unfixed or 127 1: Standard
2 to 127: Unknown
Unfixed: Unknown
-
Tire Circumference Compensation when tires are replaced Short 3, Short 2, Short 1, Standard, Long 1, Long 2 or Long 3 Short 3: Small 3
Short 2: Small 2
Short 1: Small 1
Standard: Standard
Long 1: Large 1
Long 2: Large 2
Long 3: Large 3
-
# Codes Number of stored DTCs 0 to 255 Number of DTCs will be displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test by referring to the table below.

Body Electrical > Combination Meter > Active Test
Tester Display Control Range Diagnostic Note
Intelligent Parking Assist Indicator S-IPA indicator light on/off -