Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0244874 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  Vehicle does not Move to Set Parking Position  


CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the simple intelligent parking assist system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

·

If initialization is necessary while performing an inspection, perform initialization first and then proceed to the next step.



PROCEDURE

1.CHECK TIRE SIZE
a.

Check that the tire pressure and tire size are as specified.


b.

Check that there is no excessive wear on the tires.


Result:
Result Proceed to
Tire size is as specified and there is no excessive wear A
Tire size is not as specified but there is no excessive wear
Tire size is as specified but there is excessive wear B
Tire size is not as specified and there is excessive wear
Tire size is totally different from specified size



A

2.CHECK TIRE ROTATION

B

REPLACE TIRES

2.CHECK TIRE ROTATION
a.

Check tire movement distance.

E127424C03
3.518,0.18 3.697,0.36 0.179,0.179 10 *a 5.913,0.54 6.093,0.684 0.179,0.145 10 *b 3.518,2.338 3.697,2.517 0.179,0.179 10 *c 5.367,1.805 5.815,0.608 5.815,0.608 5.899,0.608 false
*a 5 Rotations *b Chalk Mark
*c Movement Distance (A) - -


i.

On a level surface, center the steering wheel and stop the vehicle.


ii.

Apply chalk to a point on the tire and on the ground.


iii.

Drive the vehicle straight ahead, and stop the vehicle after the tire rotates 5 times.


iv.

Apply chalk to the ground at the same position as the chalk applied to the tire. Measure the movement distance (A). After measuring the movement distance (A), calculate the tire diameter using the following formula and check that it is within the standard range.

Formula:

Tire diameter (mm (ft.)) = Movement distance (A) (mm (ft.)) / 5 rotations / 3.14


OK:

615 mm (2.017 ft.)




Result:
Proceed to
OK
NG



OK

3.CHECK WHEEL ALIGNMENT

NG

PERFORM UTILITY (TIRE CIRCUMFERENCE SETTING)

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>UTILITY

HINT:

If the problem symptom does not disappear after performing Utility (Tire Circumference Setting), replace the tires with new ones.



3.CHECK WHEEL ALIGNMENT
a.

Perform the front wheel alignment inspection.

HINT:

For alignment inspection, follow the toe-in and camber specifications.

Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT


OK:

Alignment is within specifications.



b.

Perform the rear wheel alignment inspection.

HINT:

For alignment inspection, follow the toe-in and camber specifications.

Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>REAR WHEEL ALIGNMENT>ADJUSTMENT


OK:

Alignment is within specifications.



Result:
Proceed to
OK
NG



OK

NG