These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus "A" Off | Control module communication bus off | CAN communication system |
| U0100 | Lost Communication with ECM / PCM "A" | Lost communication with ECM | CAN communication system |
| U0124 | Lost Communication with Lateral Acceleration Sensor Module | Lost communication with yaw rate and acceleration sensor | CAN communication system |
| U0126 | Lost Communication with Steering Angle Sensor Module | Lost communication with steering sensor | CAN communication system |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU | CAN communication system |
| U0131 | Lost Communication with Power Steering Control Module | Lost communication with power steering ECU assembly | CAN communication system |
| U0140 | Lost Communication with Body Control Module | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | Lost communication with meter circuit plate | CAN communication system |
| U0164 | Lost Communication with HVAC Control Module | Lost communication with air conditioning amplifier assembly | CAN communication system |
| U0293 | Lost Communication With Hybrid Powertrain Control Module | Lost communication with hybrid vehicle control ECU assembly | CAN communication system |
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING