Home › Engine / Hybrid System › 2ZR-FXE LUBRICATION › OIL PRESSURE SWITCH
RM3210E _51 Engine / Hybrid System _047500 2ZR-FXE LUBRICATION _0244879 OIL PRESSURE SWITCH A

2ZR-FXE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.
A304094C12
1.469,0.344 1.646,0.344 1.646,0.344 1.927,0.688 false 1.813,1.229 2.01,1.563 2.01,1.563 2.24,1.563 false 1.302,0.229 1.615,0.385 0.313,0.156 10 false *a 2.281,1.458 2.594,1.615 0.313,0.156 10 false *b
*a Adhesive
*b Oil Inlet Port


Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

·

Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.




b.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



c.

Connect the engine oil pressure switch assembly connector.