Home › Engine / Hybrid System › 2ZR-FXE LUBRICATION › OIL PRESSURE SWITCH
RM3210E _51 Engine / Hybrid System _047500 2ZR-FXE LUBRICATION _0244879 OIL PRESSURE SWITCH G

2ZR-FXE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

CAUTION:
·
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the power switch on (IG).

·
A344783

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.



a.

Disconnect the engine oil pressure switch assembly connector.


b.

Put the engine in inspection mode (maintenance mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


c.

Start the engine.


d.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
Engine stopped Below 1 Ω


If the result is not as specified, replace the engine oil pressure switch assembly.


e.

Connect the engine oil pressure switch assembly connector.