Home › Power Source / Network › 2ZR-FXE BATTERY / CHARGING › AUXILIARY BATTERY
RM3210E _57 Power Source / Network _047502 2ZR-FXE BATTERY / CHARGING _0244884 AUXILIARY BATTERY A

2ZR-FXE BATTERY / CHARGING  AUXILIARY BATTERY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AUXILIARY BATTERY

a.

Install the battery insulator to the auxiliary battery.


b.

Install the auxiliary battery.


c.
A378515

Set the No. 2 battery clamp as shown in the illustration.


d.

Install the bolt.

Torque:
15.4 N*m (157 kgf*cm, 11 ft.*lbf)


e.

Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

Torque:
5.6 N*m (57 kgf*cm, 50 in.*lbf)


f.

Engage the 2 claws to close the battery terminal cap.


Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION