Home › Power Source / Network › 2ZR-FXE BATTERY / CHARGING › BATTERY CURRENT SENSOR
RM3210E _57 Power Source / Network _047502 2ZR-FXE BATTERY / CHARGING _0244885 BATTERY CURRENT SENSOR A

2ZR-FXE BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder.


b.

Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



d.

Connect the battery state sensor assembly connector.


e.

Engage the 2 claws to connect the wire harness to the battery current sensor holder.