Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0244900 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U012287  Lost Communication with Vehicle Dynamics Control Module Missing Message  U029387  Lost Communication With Hybrid Powertrain Control Module Missing Message  U110487  Lost Communication with Driving Support ECU Missing Message  


DESCRIPTION

The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message When the power switch is on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake booster with master cylinder assembly) and the hybrid vehicle control ECU is detected for approximately 2.6 seconds or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)

·

Network Gateway ECU


U029387 Lost Communication With Hybrid Powertrain Control Module Missing Message
w/o Full-speed range following function:
·

While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more.


w/ Full-speed range following function:
·

While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more.


·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)

·

Network Gateway ECU


U110487 Lost Communication with Driving Support ECU Missing Message
w/o Full-speed range following function:
·

While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and hybrid vehicle control ECU is detected for 1 second or more.


w/ Full-speed range following function:
·

While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and hybrid vehicle control ECU is detected for 1 second or more.


·

CAN communication system

·

Hybrid vehicle control ECU

·

Driving support ECU assembly

·

Network Gateway ECU



PROCEDURE

1.CHECK FOR DTCs (RADAR CRUISE 1)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 399

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).

3.

w/ Full-speed range following function: Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.

w/o Full-speed range following function: Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 399

Result:
Result Proceed to
DTC U012287, U029387 and U110487 are not output A
DTC U012287, U29387 or U110487 is not output B



A

B