Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) › 2015.11–2016.08
RM3210E _58 Vehicle Interior _047538 SEAT BELT _0244926 SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) U

SEAT BELT  SEAT BELT WARNING SYSTEM(w/ Occupant Classification System)  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter, Occupant Detection or SRS Airbag / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer ON or OFF Customize setting displayed -
P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer ON or OFF Customize setting displayed -
Body Electrical > Occupant Detection > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Passenger Buckle SW Front passenger buckle switch Unset, Set or NG Unset: Seat belt not fastened
Set: Seat belt fastened
NG: Data is not determined
-
Body Electrical > SRS Airbag > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Left side Buckle SW LH buckle switch Unset, Set or NG Unset: Seat belt not fastened
Set: Seat belt fastened
NG: Data is not determined
-
Right side Buckle SW RH buckle switch Unset, Set or NG Unset: Seat belt not fastened
Set: Seat belt fastened
NG: Data is not determined
-


ACTIVE TEST


Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Driver Side Seat Belt Seat belt warning light ON or OFF -