INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
Perform this inspection with the customize parameters at the initial settings.
Perform this inspection with the door switch of the map light assembly on.
| Control | Condition | Lights that Operate |
|---|---|---|
| Actuation Area-linked | With the power switch off and all of the doors closed and locked, enter an exterior detection area while carrying an electrical key transmitter and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Footwell Light* |
| Door Lock/Unlock-linked | With the power switch off and all of the doors closed and locked, unlock either front door using an unlock operation (key-linked, wireless or entry unlock operation) and check that the lights that operate turn on for 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Footwell Light* |
| Door Open/Close-linked | With the power switch off and all of the doors closed, open either front door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds. | ·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Footwell Light* |
| With the power switch off and all of the doors closed, open either front door and check that the light that operates turns on. While the light that operates is on, close all of the doors and check that the light that operates turns off after approximately 40 seconds. | Power Switch Illumination | |
| With the power switch on, open either front door and check that the lights that operate turn on. While the lights that operate are on, close all of the doors and check that the lights that operate turn off. | ·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Footwell Light* |
|
| Power Switch-linked | Turn the power switch from on (ACC) or on (IG) to off and check that the lights that operate turn on for approximately 15 seconds and then turn off. | ·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Footwell Light* |
| Turn the power switch from on (ACC) or on (IG) to off and check that the light that operates turns on for approximately 40 seconds and then turns off. | Power Switch Illumination |
*: w/ Footwell Light
INSPECT BATTERY SAVING FUNCTION
The operations and conditions of this control are described below.
| Control | Condition | Lights that Operate |
|---|---|---|
| Basic operation | When 20 minutes elapse after the power switch is turned from on (ACC or IG) to off and the lights that operate remain on, the lights are turned off.
|
·
Power Switch Illumination ·
Map Light Assembly ·
No. 1 Room Light Assembly |
| Interior light auto cut operation | When 20 minutes elapse after the power switch is turned from on (ACC or IG) to off and the lights that operate remain on, the lights are turned off.
|
·
Map Light Assembly ·
No. 1 Room Light Assembly ·
Vanity Light Assembly ·
No. 1 Luggage Compartment Light Assembly ·
Courtesy Light Assembly |