Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM3210E _53 Suspension _047545 TIRE PRESSURE MONITORING _0245054 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C270968E39
4.844,2.021 6.25,2.469 1.406,0.448 10 false Tire Pressure Warning ECU and Receiver 5.031,0.615 5.25,0.875 0.219,0.26 10 false IG 5.031,1.156 5.406,1.365 0.375,0.208 10 false GND 4.833,0.51 4.979,0.76 0.146,0.25 10 false 1 4.771,1.042 4.958,1.26 0.188,0.219 10 false 12 0.938,0.635 1.896,0.875 0.958,0.24 10 false from IG Circuit 3.208,0.802 4.448,1.052 1.24,0.25 10 false ECU-IG1 NO. 4 4.854,1.844 6.646,2.042 1.792,0.198 10 false M14

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER POWER SOURCE)
a.
C250865C81
0.229,0.854 0.604,1.115 0.375,0.26 2.219,1.469 2.594,1.698 2.594,1.698 2.76,1.698 true 0.74,1.698 0.885,1.698 0.885,1.698 1.208,1.25 true 0.094,0.083 0.406,0.24 0.313,0.156 10 false *a 0.271,0.906 0.729,1.104 0.458,0.198 10 false M14 2.802,1.615 3.26,1.813 0.458,0.198 10 false GND 0.563,1.615 1.021,1.813 0.458,0.198 10 false IG
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


Disconnect the M14 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
M14-1 (IG) - Body ground Power switch on (IG) 10 to 16 V
Power switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M14-12 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR